The 7796HF is an extended frequency version of the 7796 amplifier. The 7796HF has a power bandwith of 100kHz. The amplifier can drive a wide range of loads from less than 1ohm to open circuit. At lower voltages it is capable of significant ouput past 200kHz. The 7796HF works well with continuous or pulse test signals.

• 60VuSec Slew rate*, multiple units can be connected in series for slew rates in excess of 100VuSec*
• Power bandwidth of DC - 100kHz, DC - 200kHz available at lower voltages
• Rugged chassis for stand-alone benchtop or rack-mounted operation
• Protection circuitry hardens the 7796HF to input overloads, improper output connection (including shorted and improper loads), over-temperature, over-current and incorrect supply voltage
• Shipped ready to operate from 208 volt, three-phase AC mains. Operation from 380 or 415 volt AC mains are available

Frequency Response
(DC – 100kHz at 1 watt into 8ohms)
Phase Response
+/- 8.3 degrees (10Hz - 10kHz)
Signal Delay
(From amplifier input to output) 2.3uSec
Slew Rate
Maximum 60 Volts per uSec
Unit To Unit Phase Error
+/- 0.1 Degrees @ 60Hz
Output Offset Current
Less than 10 Milliamperes DC (user trim-able to 0).
Input
Balanced w/ Ground: 3 Terminal Barrier Block
Connector 20k Ohm Differential
Unbalanced: BNC Connector, 10k Ohm Single Ended
Gain
20 Volts/Volt (Voltage Mode)
20 Amperers/Volt (Current Mode)
Residual Noise
DC - 30kHz Less than 100uVolts
DC - 100kHz Less than 1mVolts

Chassis
All aluminum construction designed for stand alone or rack mounted operation with black chassis.
The 7796HF occupies seven EIA 19-inch-wide rack units.
Weight
153 lbs. (69 kg)
AC Power
Three phase, 208 volts, 47-60Hz, 15 amperes AC Service
Three phase, 400 volts, 47-60Hz, 10 amperers AC Service
Cooling
Forced Air, 500 cfm.
Dimensions
19 in. x 12.25 in. x 22.8 in. (48.3 cm x 31.1 cm x 57.9 cm)

When you purchase an AE Techron amplifier, a full complement of technical and factory support personnel join your team. AE Techron, Inc. provides:
• Applications engineering for your technical questions and customized product needs.
• A one year limited warranty to protect your equipment investment.
• A fully equipped service center to keep your amplifier operating at original performance requirements.

Amplifiers connected to 4ohm, 3uH load.

Both amplifiers operated with their power supply locked low.

The 7796 and 7796HF amplifiers are capable of higher voltages below 80kHz depending on load.

• Front panel LEDs indicate ready, standby and fault conditions in output stage.
• Front panel display lists type of fault condition and gives suggested corrective action.
• Front panel soft touch switch to place amplifier in run or standby mode.
• Front Panel is user configurable for up to four simultaneous displays reporting one, two or all four of the following: Voltage Peak, Voltage RMS, Current Peak, and Current RMS.