APPLICATION
The LV 3622 is a single channel linear amplifier, specifically designed to drive high impedance loads at high voltage levels. The LV 3622 features isolated inputs and outputs that allow three LV 3622 amplifiers to be connected in a wye configuration with common neutral for power utility or related applications. The LV 3622’s versatility makes it useful in industrial and commercial power applications including power system modeling, shaker tables, low frequency building resonators. The LV 3622’s low distortion level makes it ideal for drive actuators, servos and other positioning units. AE Techron’s LV 3622 is also used to supply clean power for processes, drive transducers and simulate Europe’s 50 Hz power sources.

FEATURES
> Output up to 630 watts continuous power into 24 ohms.
> Front panel indicators for rapid assessment of amplifier status.
> Designed to survive input overloads, improper output connection (including improper loads) and continuous operation under
demanding conditions.
> Optically isolated, balanced input combined with floating output connectors provide complete isolation from chassis ground.
> Shipped ready to operate from 100, 120, 220, 230 or 240 -volt single phase, 47-63 Hz, 15 amp, AC power source.
> Installs easily into a standard 19 inch rack and occupies only 3.5” of rack space.

INDICATORS AND CONTROLS
> Front panel LEDs indicate output overload
> A pushbutton power “On/Off” located on the front panel
> Two circuit breaker resets on the back panel
> An input barrier block on the back panel
> Four output terminals, with 5-way binding posts, on the back panel.

PERFORMANCE (One hour continuous ratings)
Frequency response
. dc to greater than 50 kHz, 5-30 kHz +0,-1 dB.
THD + Noise
. Less than 0.10% at 600 hz, full output power
Residual Noise
. Less than 10 millivolts peak (40 Hz to 600Hz).
Differential Phase Error
Less than 0.1 degree at 60 Hz. (unit to unit)
Input Impedance
. 50.0 kOhms differential.
Output impedance
. Less than 10 milliohm
Input Impedance
. 50.0 kOhms differential.
Output load constraints
24 ohm minimum, 0-90º
Gain
30 or 60 volts/volt +/- 0.2% internally selectable.

OUTPUT POWER
Measurements taken at 1 kHz at .05% THD with amplifiers operating in controlled voltage mode.

PHYSICAL CHARACTERISTICS
Chassis: The Amplifier is designed for stand alone, or rack mounted, operation. The Chassis is black steel with a silver finished aluminum front panel. The unit occupies two EIA 19-inch-wide units.
Weight: 56 lbs. (25.4 kg)
AC Power: Available in 100, 120, 220, 230, or 240 volt single phase, 47-63 Hz, 15 amperes ac service. Call for
more information.)
Cooling: Forced air. Intake through removable filters on the front panel, exhaust through side panels.Dimensions: 19 in. x 18.5 in. x 3.5 in (48.3 cm x 47.0 cm x 6.4 cm)

SUPPORT
When you purchase an AE Techron amplifier, a full complement of technical and factory support personnel join your team. AE Techron provides:
> Applications engineering for your technical questions and customizedproduct needs.
> A one year limited warranty to protect your equipment investment.
> A fully equipped service center to keep your amplifier operating at original performance requirements.

To download a PDF file of this specification sheet, click here.